MaximaLabs
Simulation gallery

Wet-process phosphoric acid on a Khouribga rock analysis: impurities to acid and gypsum

Phosphoric acidFertilizerGypsumRock impuritiesMER
See it live
Open this exact flowsheet in the workspace, already solved — tweak a spec and re-run.
Launch interactive model

The dihydrate line of the companion example, fed instead with the Khouribga (Morocco) rock analysis in Table 1 of the EFMA BAT booklet No. 4 on phosphoric acid: 33.4% P2O5, 4.5% CO2, 4.0% F, 1.9% SiO2, 1.6% SO3, 0.4% Al2O3, 0.2% Fe2O3, 0.3% MgO. The minerals are rebuilt from that analysis by rock_from_analysis: apatite from the P2O5, fluorite from the fluorine above the apatite's, calcite from the CO2, anhydrite from the SO3, and the three impurities as their oxides; every analysed oxide the model carries is reproduced exactly, and the CaO those minerals imply (52.3%) is shown beside the 50.6% measured. The booklet's Na2O (0.7%) and K2O (0.1%) are left out because no source read gives the fraction of either that the attack dissolves, and the reactor refuses an impurity without one; organics, Cl and SrO (0.5% together) are not carried. 4,830 t/d of rock makes 1,523 t/d of P2O5 as a 28.0 wt% filter acid at 94.4% recovery. The impurity split is one measured point, not a property of this rock: Liang et al. (Min. Metall. Process. 34(3), 2017) dissolved 61% of a Florida rock's Fe2O3, 85% of its Al2O3 and 96% of its MgO in a 75 C dihydrate attack. With the dissolved share washed like the acid, 60.0% of the iron, 83.6% of the aluminium and 94.4% of the magnesium reach the product acid and the rest leaves with the gypsum. The Minor Element Ratio, (Fe2O3 + Al2O3 + MgO)/P2O5, is 0.0269 for the rock and 0.0234 for the acid; the acid's P2O5/Fe2O3 of 263 is far above the minimum of 20 one producer sets for MAP 11-52 (Ribeiro et al., ACS Omega 2025). Dissolving the impurities takes 21.7 mol/s of acid protons, reported but not charged to the sulfuric acid feed, which is sized at 2.5% excess over the attack and the carbonate as in the companion example. Not modelled: what the impurities do to the acid's viscosity and water activity, the fluorine they bind, and the post-precipitation sludge they form when the acid is concentrated; no source read quantifies them. The filter is not sized here, because the cake resistance measured for one rock does not carry over to another.

The flowsheet

The solved topology — every unit op's real duty, conversion, or split, read straight off a genuine converged solve.

Phosphate ROCK
Sulfuric ACID
WASH Water
rock
acid
wash
gas
acid
cake
PAR
Filter ACID
Gypsum CAKE
OFF GAS

The stream table

Every stream's flow, temperature, pressure, and composition — real converged numbers, not placeholders.

See it live
Open this exact flowsheet in the workspace, already solved — tweak a spec and re-run.
Launch interactive model

Stop fighting legacy software. Build your first flowsheet in 60 seconds.