MaximaLabs
Back to gallery

Comminution Process Flowsheets & Simulations

Explore 2 validated, solved Comminution simulation flowsheets in MaximaLabs — real components: quartz, water, co2. Open any one directly in your browser.

Solved via: COOLPROP, PENG-ROBINSON.

Slurry Solids
Slurry Water
slurry
fine
coarse
HC
Underflow
Overflow
Reference model

Grinding-circuit hydrocyclone classifier

A hydrocyclone classifies a mineral slurry by particle size — the unit that closes every closed-circuit grinding loop (mill → cyclone, coarse underflow recycled to the mill). A quartz slurry (200 µm mean, spread by a log-normal PSD) is split about a 100 µm corrected cut size (Plitt 1976): the coarse solids report to the thick underflow and the fines to the dilute overflow, split by the short-circuit recovery. The underflow comes out much coarser (~300 µm mean) than the overflow (~80 µm), and the solids mass balance closes exactly. Honest scope: the d50c is the real Plitt correlation, but the partition sharpness and water recovery are screening params.

5 unit ops • COOLPROP

80 0

View & open
ORE
MILL
feed
over
under
Screen
Oversize
Product
Reference model

Grinding circuit: what a size reduction costs

Ore at 1 mm is ground to a 100 micron P₈₀ and screened at 150 microns. The number the example exists for is the 172.3 kW the mill draws, and it is not a parameter — it is Bond's Law computed from the size reduction itself: W = 10 x Wi x (1/sqrt(P₈₀) - 1/sqrt(F₈₀)) with sizes in microns gives 9.57 kWh/t at a Bond work index of 14, and 18 t/h of ore turns that into 172.3 kW. Halve the product size again and the law's inverse-square-root shape is what tells you the power does not halve — comminution is where a mineral plant's electricity goes, and this is the relationship that decides it. The screen then splits the ground product 27.9% oversize / 72.1% undersize, and it genuinely sorts: the oversize leaves at a 247 micron mean against the undersize's 81 microns, from one 100 micron feed. The cut is applied to the real size distribution (GSD 2.0), not as a specified split fraction. Open circuit, and that is a limitation rather than a choice. A real grinding circuit recycles the screen oversize back to the mill, and it cannot be drawn here: a mixer flashes its outlet and drops the stream's solids payload, so the recycled ore arrives at the mill with no particle size and the mill rejects it. The same limitation stops a cyclone feeding a baghouse in series (see the dust-collector example). Stated here because an open circuit reports a lower circulating load and a coarser product than the closed circuit a plant actually runs.

5 unit ops • PENG-ROBINSON

10 0

View & open

Stop fighting legacy software. Build your first flowsheet in 60 seconds.