ZLD Process Flowsheets & Simulations
Explore 2 validated, solved ZLD simulation flowsheets in MaximaLabs — real components: water, nacl. Open any one directly in your browser.
Solved via: PENG-ROBINSON.
Industrial water reuse: RO + membrane distillation to near-ZLD
A chemical-site water-reuse train of the kind large industrial water users build when the intake is salinising and freshwater is getting scarce: reverse osmosis makes reuse-grade water, the RO concentrate is warmed by low-grade waste heat and pushed further by membrane distillation, and the MD concentrate is crystallised to salt. Overall water recovery comes out at 94.9%. The point of the flowsheet is why MD is there at all. RO is pressure-driven, so its ceiling is osmotic pressure — and this feed hits that wall hard: at 25 bar the same 75% recovery is infeasible, and the model says so with a number rather than a shrug (osmotic pressure 27.2 bar against a 25 bar feed, a structured SPEC_THERMODYNAMICALLY_IMPOSSIBLE error, which is why the feed here runs at 45 bar). Membrane distillation is driven by a vapour-pressure difference instead, so only vapour crosses and there is no osmotic ceiling at all: it takes the RO concentrate from 2.0 mol% to 9.7 mol% salt, recovering 81% of the water RO had to leave behind, and its distillate is solvent-only. The waste-heat coupling is not decoration. At the RO concentrate's own 25 C the MD flux is about 1 kg/m2/h and the module is pointless; warmed to 60 C it runs at 21.5 kg/m2/h, inside the 10-50 kg/m2/h band real DCMD modules achieve. That is the entire commercial case for MD — it is a heat-driven process, so it is only cheap where low-grade heat is already being vented.
9 unit ops • PENG-ROBINSON
11 0
View & openSite water reuse: RO + EDI polish + MD to near-ZLD
The full hybrid a large chemical site builds when it is reusing its own effluent rather than buying river water: reverse osmosis does the bulk desalting, electrodeionisation polishes the permeate to boiler-feed quality, and the RO concentrate is warmed by waste heat and pushed to salt by membrane distillation and a crystalliser. It is the companion to industrial-water-reuse-ro-md-zld, which stops at reuse-grade water; the delta here is the polishing leg, and it is a genuinely different technology rather than a tighter membrane. Why EDI and not more RO. RO is pressure-driven and pushes water, so its energy scales with the volume produced. Electrodialysis drags ions out under a field and the water never crosses, so its energy scales with the salt removed — which is why it is hopeless on seawater and excellent on an RO permeate that is already 99% desalted. This model shows that rather than asserting it: at the same stack and current the moles removed are fixed by Faraday's law regardless of how salty the feed is. The reason the polisher is resin-filled is the interesting part. Plain electrodialysis has a limiting current density proportional to the diluate concentration, so as the water approaches pure the boundary layer runs out of ions to deliver and the salt flux plateaus — ED cannot reach ultrapure at any voltage, and the voltage runs away as the water stops conducting. Packing the diluate compartment with ion-exchange resin fixes both: the resin carries the current, and the water splitting that occurs above the classical limiting current — a fault in a solution-filled stack, causing a pH excursion and scale — is exactly what regenerates the resin in place. That is why an EDI polisher needs no chemical regeneration, and why the same operating point means opposite things in the two stacks.
11 unit ops • PENG-ROBINSON
10 0
View & open